How to install LED light bar casing? First of all, you can directly tear off the sticker on the surface of the 3M double-sided adhesive during installation. The size of the power supply is calculated according to the power and length of the led strip. You can also buy a high-power switching power supply as the total power supply, and the control distance of each controller is different to consolidate the waterproof effect of the connection point, and it can be cut off if it is longer.

      For outdoor installation, the method is the same as indoor installation: but it is necessary to pay attention to the waterproof problem. When installing, it must be installed in accordance with the manufacturer’s requirements. All the LED flexible light bar input power sources are all connected in parallel (if the wire size is not enough) Can be extended additionally). The led light bar is a circuit structure composed of 3 LEDs in series and parallel. The control distance of the remote controller is 15 to 20 meters. The installation is relatively simple. If it is fixed with 3M glue, it is safe and reliable. The strips get hot easily. As for some places where you need to turn or the length of the led light bar is not consistent. Therefore, when installing the LED light bar, every 3 LEDs can be cut off.

     In short, when the LED light bar is used outdoors, it will be exposed to rain and the requirements for UV protection are not high. Do not let the LED light bar run overload. The advantage of this is that it can be controlled centrally. It is not clear how to install it. The control distance of the simple controller is 10 to 15 meters.

When the LED light bar is used for interior decoration, it is also necessary to consider the configuration of the controller, the fixed installation position of the LED light bar, how much power is needed, and which method to use can be measured by yourself.